KR
- It provides the best static elimination effect at a distance of 15cm to 20cm, operates stably up to a distance of about 3m, and enables static elimination at a line speed of 300 to 500m/min.
- It eliminates static electricity regardless of whether it is static electricity, and there is no generation of harmful ozone.
- It is a low-power type with a power consumption of 2-5W, and it removes static electricity from large spaces by repeatedly radiating even on complex shapes.
- Eliminates static without using air-blow, preventing the generation of particles and dust.
- Can be installed and operated under any conditions, from vacuum to atmospheric pressure.
| Item | ZERO Buster | Ionizer Static Elimination Device |
|---|---|---|
| Ozone Generation | Does Not Occur | Occurred |
| Electrode Dust | Rash is Almost Zero | Dust generation due to electrode needle oxidation |
| Blower | None (Blower not in Use) | Available (Using Blower) |
| Elimination in Vacuum | Possible (10-4 Torr More) | Impossibility |
| Power Consumption | 2 ~ 5W Power Saving Type | 150W ~ 200W |
| Safety | No Risk of flammable gas ignition | Risk |
| Noise Generation | X | O |
* Our company’s test (in a 20% hydrogen gas atmosphere). However, please stop using this static extinguisher in legally hazardous locations or when using flammable solvents.
Radial Electrostatic Removal System
- It prevents particle scattering without air blow and offers excellent electrostatic removal performance.
- Neutralizes and removes static electricity regardless of positive or negative static electricity.
- It also neutralizes and removes static electricity inside and on the back of the pipe.
- It improves particle contamination caused by static electricity and material wrinkling.
- There is no risk of ignition due to flammable gases.
- It significantly reduces the burden on the operator.
Static Decay Time
Based on the time required to discharge the initial voltage from ±5,000V down to 0V.
At 100mm distance
(Ultra-close, express static elimination)
Approx0.3seconds
At 300mm distance
(Standard working distance)
Approx1.0second
At 500mm distance
(Mid-range static elimination)
Approx4.0seconds
Examples of implementation effects
When peeling off the protective film, static electricity is removed,
allowing it to be wound neatly.
Installation Example
This is an example of an installation of an electrostatic discharge system.
- Feeding and input section
It is attached to the paper or film entry points (feeder sections) of printing presses and other equipment to block static electricity generated during material feeding in advance.
- Winding and loading section
- Special environmental process clean room
- Vacuum Chamber